Kenmerken
Lichtgewicht schuilplaats voor bergbeklimmers gebouwd met bomber basecamp materialen gemaakt om de meest ruige avonturen in de hoge Alpen te weerstaan.
De goudgele kleur van de Battle Mountain werd aangevraagd door Chhiring Dorje Sherpa om de Tibetaanse boeddhistische godin van voorspoed en geluk, Miyo Losangma, te eren. Zij woont op de Mount Everest en is gul voor degenen die haar dankbaarheid tonen. Haar huid is goudgeel, dus als Chhiring deze tenten opzet zullen ze opvallen als een eerbetoon aan haar.
Duurzame polyester ripstop met hoge sterkte, uitzonderlijke scheurvastheid, UV-bestendigheid en stabiliteit bij temperatuur- en vochtschommelingen - ideaal voor omstandigheden op grote hoogte.
Voorzien van twee deuren en twee vestibules
Twee deuren met dubbele ritssluiting en ramen met twee sluitingsmogelijkheden: alleen gaas voor ventilatie, of rits de nylon laag dicht voor volledige afsluiting
Twee vestibule-deuren: een deur met enkele rits en een deur met dubbele rits, ontworpen om te worden opgezet als luifel met behulp van trekkingstokken
Stormflappen op de rits van de vestibule
Kleurgecodeerde banden en stokken maken het opzetten eenvoudig
DAC oversized twist clips gemakkelijk te bevestigen aan stokken systeem, zelfs met handschoenen aan
Hoge/lage interne stormlussen voor extra stabiliteit bij harde wind
Twee ventilatieopeningen voor een betere luchtstroom en minder condensatie; volledig afsluitbaar bij extreem weer
Extra grote 3-D opbergvakken zorgen voor voldoende opbergruimte zonder afbreuk te doen aan uw leefruimte
Klittenbandlipjes verbinden de tent aan de paalstructuur voor een perfecte stand en extra stabiliteit
Klaar om op te zetten; met voorgesneden afspanlijnen en spanners bevestigd aan de tentdoek
Zware reflecterende afspanlijnen en reflecterende banden
Om de levensduur van uw tentvloer te verlengen, raden wij u aan een Big Agnes grondzeil te gebruiken - apart verkrijgbaar
Meerdere lussen aan de binnenkant voor het bevestigen van accessoires en mtnGLO® Tent & Camp Lights
Specificaties
Materialen
De buitentent is gemaakt van Dominico® ongeverfd polyester ripstop met garens met een hoge sterktegraad die de scheursterkte met 20-25% verhogen ten opzichte van standaard nylon of polyester ripstopstoffen. Biedt ook een hoge UV-bestendigheid en stabiliteit bij temperatuur- en vochtigheidsschommelingen, waardoor de tent stevig en stabiel staat.
De buitentent is behandeld met siliconen en heeft een 1200 mm waterdichte polyurethaan coating plus een extra coating aan de buitenkant van de stof voor meer scheurvastheid en UV-bestendigheid.
De vloer is van nylon tafzijde met een 10.000 mm waterdichte polyurethaan coating
De tent bestaat uit nylon ripstop ademend en polyester mesh
Het materiaal maakt gebruik van een uniek pigment kleurproces dat het vervagen tegengaat en de UV-bestendigheid verhoogt; dit verlengt de levensduur van de stof bij gebruik in omstandigheden op grote hoogte.
Alle naden getapet met waterdichte, oplosmiddelvrije polyurethaan tape (geen PVC of VOC's)
DAC NSL stokkensysteem met press fit connectoren en lichtgewicht hubs, DAC H Clip en Twist clips bevestigen de tent aan de tentstokken.
Hub stok ontwerp
x2 3D-wandvakken, x2 gaaswandvakken, x4 gaasplafondvakken met doorgangen voor koorden
Inclusief 13x 7,5" Big Agnes Dirt Dagger™ UL tentstokken - kunnen worden ingegraven als dodemansankers
Extra grote uitzetlussen voor gebruik met ski's, ijsbijl, skistokken, enz.
Gear loft lussen inbegrepen
Fast Fly opstelling beschikbaar
Inclusief opbergvak
Footprint - apart verkrijgbaar
Beoordelingen
We verifiëren sommige beoordelingen en waar dat het geval is, geven we dat ook aan. Hier vind je meer informatie .
Zorg
Tent en Footprint Reinigings- en onderhoudsinstructies:
Opbergen:
Zorg er altijd voor dat uw tent droog en vrij van vuil is voordat u hem opbergt. Vouw en rol de tent elke keer op een andere manier op om permanente kreuken te voorkomen. Bewaar de tent op een koele, droge plaats. Laat uw tent nooit voor langere tijd op een warme plaats staan (zoals in een kofferbak of op een zolder), omdat dit de coating van het materiaal beschadigt. Als u uw tent vochtig opslaat, kan er schimmelvorming optreden, waardoor uw tent kan gaan stinken, lekken of delamineren. Schade door schimmel wordt niet gedekt door de garantie.
Reiniging:
Voor een lichte reiniging spons je het product af met warm water (niet heet).
Voor een grondiger reiniging hebt u het volgende nodig
-wasbak (of badkuip)-warm water (niet heet)
-Waterbestendige Gear Cleaner (wij raden producten aan zoals Nikwax Tech Wash)
-Spons
1. Dompel je uitrusting onder in warm, schoon water. Roer voorzichtig met je handen. Giet het vuile water weg. Herhaal dit totdat het meeste overtollige vuil is verwijderd en het water grotendeels helder is.
2. 2. Breng de waterproof gear specifieke was aan en verwerk de stof voorzichtig met een spons.
3. Spoel de uitrusting grondig uit.
4. Hang ze op om te drogen.
5. Controleer drie keer of je spullen helemaal droog zijn voordat je ze opbergt of gebruikt.
*Geen chemisch reinigen of wassen in de wasmachine. Wasmiddelen en oplosmiddelen voor de stomerij beschadigen de stof en ruïneren de waterdichtheid.
*Gebruik nooit heet water, bleekmiddel, vloeibare wasmiddelen of afwasmiddelen.
*Volledig laten drogen voor opslag of gebruik.
*Vermijd langdurig direct zonlicht, blootstelling aan UV-straling kan de waterdichtheid aantasten.
Naadafdichting:
Big Agnes tenten zijn geseald als onderdeel van ons productieproces! Deze naadtape alleen al is duurzaam genoeg om waterlekkage te voorkomen. Naden die zijn afgeplakt hoeven niet te worden afgedicht met een vloeibare sealer, tenzij je extra bescherming wilt. Zorg ervoor dat de naadafdichting volledig droog is voordat u de tent weer inpakt. Schade door verkeerd aanbrengen kan de garantie doen vervallen.
Ritsen:
Door uw ritsen schoon te houden, voorkomt u dat de windingen en schuivers slijten. Als de ritsen vol zitten met vuil, stofzuig of borstel ze voordat u de tent opbergt. Wij raden Gear Aid ritssluitingsreiniger en -smeermiddel aan.
Reparaties en garantie:
Alle Big Agnes tenten zijn gegarandeerd tegen fabricage- of materiaalfouten. Wij geven geen garantie op producten die beschadigd zijn door normale slijtage, wijzigingen door de eigenaar, verkeerd gebruik, ongelukken of schade veroorzaakt door ander gebruik dan waarvoor ze bedoeld zijn. Schade als gevolg van verkeerd gebruik, normale slijtage of onjuiste verzorging kan naar goeddunken van Big Agnes tegen een redelijke vergoeding worden gerepareerd. Tenten die voor reparatie worden geretourneerd, moeten schoon en vrij van vuil zijn.
Vragen? Bel ons of open een support case:
877.554.8975 | support.bigagnes.com
Setup
BATTLE MOUNTAIN 2 & 3 SET UP INSTRUCTIONS
1. Remove contents from stuff sack Spread out the tent body.
2. Stake out the four corners of the tent body.
3. Assemble the pole set. 2P, assemble one main pole with two 3-way hubs, one pole with two NR joints and one pole with one NR joint. 3P, assemble one main pole with two 3-way hubs, two long pre-bent poles and one short pre-bent pole. To ensure each pole section is fully seated insert each pole section into the next by hand, instead of allowing the shock cord to snap them together.
4. Position the main pole on top of the tent body, aligning it so that the hubs are centered over the body and the ridge pole is running parallel to the doors. Match the colors of the pole ends with the matching colors of the webbing on the tent body and insert the tips of the pole into the grommets. Locate the H clips in the middle of the tent, attach them to the disks on the bottom of the hubs.
5. Attach the corresponding DAC twist clips on the tent body to the main pole.
6. 2P; position the pole with two NR joints over the front door. Match the colors of the pole ends with the matching colors of the webbing on the sides of the tent body and insert the tips of the pole into the grommets. Locate the H clips above the door, attach them to the NR joints. Take the remaining pole, position it over the back door. Match the colors of the pole ends with the matching colors of the webbing on the sides of the tent body and insert the tips of the pole into the grommets on the side of the tent. Locate the H clip above the door, attach it to the NR joint.
7. 3P; position one of the longer pre-bent poles over the front door and one over the rear door. Match the colors of the pole ends with the matching colors of the webbing on the sides of the tent body and insert the tips of the pole into the grommets.
8. Attach the remaining DAC twist clips to the poles. Attach the large hooks over both poles at the four pole intersections.
9. Drape the rainfly over the tent body and match the colors of the webbing on the fly with the webbing on the body.
10. Attach all Velcro® tabs on the underside of the fly to the corresponding pole sections for best stability.
11. Make sure the webbing at the corners and sides of the rainfly is completely slackened. Attach the color coded buckles on the fly with the matching color coded buckles on the tent body.
12. 3P; Locate the pole sleeve above the front vestibule door and feed the short pre-bent pole through the sleeve. Insert the pole tips into the second set of grommets at the two front corners of the structure.
13. Tighten the webbing on each buckle as needed to keep the rainfly taut.
14. Stake out the vestibules then stake out all remaining guylines.
Separate 6” length pole segment included for emergency field repair. Slide repair pole over the break to act as a splint.Secure splint in place with tape.
FAST FLY SET UP INSTRUCTIONS
If you purchase the optional Big Agnes footprint for your tent, it will enable you to pitch a Fast Fly shelter while leaving the tent body behind. The Fast Fly configuration requires the footprint, tent fly, poles and stakes.
1. Lay the footprint on the ground and stake out.
2. Assemble the pole set. 2P, assemble one main pole with two 3-way hubs, one pole with two NR joints and one pole with one NR joint. 3P, assemble one main pole with two 3-way hubs, two long pre-bent poles and one short pre-bent pole. To ensure each pole section is fully seated insert each pole section into the next by hand, instead of allowing the shock cord to snap them together.
3. Position the main pole on top of the footprint, aligning it so that the ridge pole is running parallel to the front and back of the footprint. Insert the pole tips into the corner grommets.
4. 2P; position the pole with two NR joints over the head end of the main pole. Match the colors of the pole ends with the matching colors of the webbing on the sides of the footprint and insert the tips of the pole into the grommets. Take the remaining pole, position it over the foot end of the main pole. Match the colors of the pole ends with the matching colors of the webbing on the sides of the footprint and insert the tips of the pole into the grommets on the side of the footprint.
5. 3P; position one of the longer pre-bent poles over the head end of the main pole. Match the colors of the pole ends with the matching colors of the webbing on the sides of the footprint and insert the tips of the pole into the grommets. Repeat the step with the second of the longer pre-bent poles over the foot end of the main pole.
6. Drape the rainfly over the pole frame. Match the webbing colors on the fly with the matching colors of the webbing on the footprint.
7. Attach all Velcro® tabs on the underside of the fly to the corresponding pole sections for best stability.
8. Make sure the webbing at the corners and sides of the rainfly is completely slackened. Attach the buckles on the fly to those on the footprint.
9. 3P; Locate the pole sleeve above the front vestibule door and feed the short pre-bent pole through the sleeve. Insert the pole tips into the second set of grommets at the two front corners of the footprint.
10. Tighten the webbing on each buckle as needed to keep the rainfly taut.
11. Stake out the vestibules then stake out all remaining guylines.
HELPFUL HINTS FOR TENT SET UP
Our tents are easy to set up but we suggest you practice once at home before using them for the first time to avoid late night bickering with tent mates while fumbling around in the dark.
Before pitching tent, clear campsite of debris that may pierce tent floor.
We recommend staking out all corners, vestibules and guylines to increase space and ventilation. Securely staking out your tent and all guylines is crucial to maintaining the structural integrity of your tent.
Hang onto your stuff sacks or they’ll blow away and create backcountry litter.
Pull on the pole sleeve fabric when inserting poles to avoid any bunching in the material.
Push rather than pull poles through pole sleeves.
Thanks for choosing a Big Agnes tent!
Please feel free to contact us if you have any questions or comments.
support.bigagnes.com | 877.554.8975
Installatie-instructies downloaden