BLACKTAIL HOTEL SET UP INSTRUCTIONS
1. Remove contents from stuff sack. Spread out the tent body.
2. Stake out the corners of the tent body.
3. Assemble the four poles: two long poles, one short cross pole and one vestibule pole. Ensure each pole section is fully seated into the next by hand instead of allowing the shock cord to snap them together.
4. Position the two long poles diagonally across the tent body, crossing at the center. Insert the pole tips into the keyed slots on the TipLok™ at the four corners of the tent.
5. Attach all of the plastic clips on the tent body to the corresponding poles.
6. Place the cross pole accross the top of the two long poles and insert the tips of the cross pole into the “Pole end clips”, located above the doors on each side of the tent.
7. Drape the rainfly over the tent body, orienting so the colors of the webbing on the rainfly match the webbing on the tent body.
8. Insert the tips of the crossover pole into the pole pockets located on the underside of the fly.
9. Make sure the webbing at the corners of the fly is completely slackened. Attach the buckles on the fly to the TipLok™ buckles on the tent body.
10. Tighten the webbing on each buckle as needed to keep the fly taut.
11. Feed the vestibule pole through the vestibule pole sleeve and insert the pole tips into the grommets on either side of the webbing strip.
12. Stake out the center point of the extended vestibule, next stake out the two ends of the webbing strip that runs between the vestibule pole.
13. Stake out and tension all remaining guylines for best stabilty, completing set up.
Low Vent Set Up: For increased ventilation, hook the cord at the bottom of the vestibule door to the toggle at the top of the zipper located on the underside of the fly.
English (EUR) | EN 
